Editing Christmas lights (section)

=Instructions=
# Run an extension cord from outlet 1 to the banister overlooking the atrium.  
# Beginning from the base of the first floor stair case, loop one 24' strand over and under the top rail (not the hand rail), one loop per baluster.  Make sure to begin with the female electrical outlet at the end.  Otherwise, you will not be able to plug it in, and will have to undo the entire strand and rewrap it.
# Repeatedly pass over the strand multiple times, tightening each time to get maximum length.
# Beginning near office 201, loop a 24' strand in the same manner.  When the first 24' runs out, plug in another 24' and continue.  Tie the connected ends to prevent separation.  Loop the strand a couple times to avoid a gap in the lights at strand connections.
# Once series 1 and series 2 are brought to a meeting point, line up the extension cord and tape it down on the carpet.  
# Plug in series 1 and series 2.
# Beginning by office 301, loop a 24' strand, moving toward the stairs.  Continue with two more 24' strands and two 13' strands, down the staircase and the mezzanine rail.
# Do a cool pose on the mezzanine.